Professional Installation System

Staplegrip, with its pneumatic Staple Gun SG-25XP and Lacing Tool, has been an innovation that has been widely accepted since its introduction in 1992. The tool is available in lengths from 12″ to 72″.

Not only does this system ease the pain of a hammer tool, it yields a stronger belt splice. All work is 100% visible at all times during installation.

The Staple Gun drives each staple with the same uniform driving force, and the unique die cavities of the Lacing Tool receive and clinch the staple to within 80 to 90% of maximum clinch. That means that the fastener strip is placed and held in compression by the single initial driving force of the Staple Gun.

After all staples are driven into the strip, a single hammer blow creates a smooth, clinched staple — all without having to turn the belt over or pull out misdirected staples. A fully clinched fastener, uniform across the entire belt width, means a stronger splice that will last longer. Field tests have proven Staplegrip does last longer. Patented.

Lacing Tool

Number
Note: Top plate included.
Specify 62, 125, or 187.
LT-12
LT-24
LT-36
LT-48
LT-60
ph_lacing_tool

Top Plates

Number
Note: Plates for 12" section.
TP-62
TP-125
TP-187
ph_top_plates

Staple Gun

Number
SG-25XP
ph_staple_gun_new

Traditional Field Lacing Tool

Includes one Field Punch and Comb. Other sizes available in 6″ increments.

Number
FT-62-6
FT-125-6
FT-187-6
FT-62-12
FT-125-12
FT-187-12
FT-62-24
FT-125-24
FT-187-24
ph_traditional_lacing

Dispenser

This functional tool dispenses two staples evenly into the guide openings of the Traditional Field Tool.

Number
D-2000
ph_dispencer

Preset Field Lacing Tool

Includes one Field Punch and Comb. Other sizes available in 6″ increments.

Number
FT-PS62-6
FT-PS125-6
FT-PS187-6
FT-PS62-12
FT-PS125-12
FT-PS187-12
FT-PS62-24
FT-PS125-24
FT-PS187-24
ph_preset_lacing

Staplegrip Combs

Combs
Note: Comb for 6" section.
TP-62-6
TP-125-6
TP-187-6
ph_supplies_comb

Staplegrip Punch

Punch
FP-2000
Staplegrip™ conveyor belt punch.

Skiver

Used to skive the cover off “rough top” belting to recess the belt lacing.

Item
RTBS-1
Conveyor belt skiver.